Arduino Ethernet Shield

sku: DEV-09026

Description: The Arduino Ethernet Shield allows an Arduino board to connect to the internet.It is based on the Wiznet W5100 ethernet chip providing a network (IP) stack capable of both TCP and UDP. The Arduino Ethernet Shield supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield.

The ethernet shield connects to an Arduino board using long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top.

Arduino uses digital pins 10, 11, 12, and 13 (SPI) to communicate with the W5100 on the ethernet shield. While using the Ethernet Shield, these pins cannot be used for general i/o.

The shield provides a standard RJ45 ethernet jack.

The reset button on the shield resets both the W5100 and the Arduino board.

Documents:

• Getting Started
• Schematic
• Reference Design
• W5100 Datasheet
• Arduino EthernetShield Page